Nexo NEMO - Manual (Page 31)

NEXO NeMo User Guide v1.3
Page 31 of 50
the current scenes are selected in green. If then you recall a scene, there
should be only one current scene, selected in blue.
If the scenes of the selected amplifiers, with a same number, have
different names, the displayed name is Multiple.
If the scenes of the selected amplifiers, with a same number, have
different saved cabinets, the displayed cabinets are Mult.
Copy/Paste
You can copy one or all the scene(s) from a NXAMP and paste them to
one or many NXAMPs. To do so, make sure the NXAMPs are equipped
with at least LOAD3_16, and:
Copy/Paste all the scenes
1. Select an NXAMP (e.g. from the Groups & devices menu).
2. From the Scene tab, tap on (copy).
3. When the copying operation is completed, select the NXAMP(s) to
paste scenes on.
4. From the Scene tab, tap on (paste). An alert appears asking you
to confirm the operation, because it will erase all the previous scenes.
Copy/Paste a scene
1. Select an NXAMP (e.g. from the Groups & devices menu).
2. From the Scene tab, tap on the row of the scene to copy, and then on
(copy).
3. When the copying operation is completed, select the NXAMP(s) to
paste scenes on (it is possible to paste the scene on the same NXAMP,
at another number).
4. From the Scene tab, tap on (paste). This will cause the copied
scene to be pasted at the same number it was on the device it has
been copied from.
5. Or, from the Scene tab, tap on a row where to paste the copied scene,
and then on .
Deleting a scene
To delete a scene, tap on the row of the scene to delete and tap on .
An alert appears to confirm the operation, which cannot be undone.