Nexo NEMO - Manual (Page 25)

NEXO NeMo User Guide v1.3
Page 25 of 50
channels.
Absolute or Relative
You can choose absolute (Abs.) or relative (Rel.) modification thanks to
the button
[Abs.|Rel.]:

If you choose
Abs., and if you change the parameter (volume, etc.) of
a selected channel, its value is also given to the other selected
channels. For instance, moving the volume slider of a selected channel
to –6 will set the volume of all selected channels to –6 dB.

If you choose
Rel., and if you change the parameter (volume, etc.) of a
selected channel, the same increase or decrease will be given to the
other selected channels. For instance, if channels 1 & 2 are selected,
where gain is respectively -1 and -6 dB, moving gain of ch. 1 to +2 dB
will set the gain of ch. 2 to -3 dB (increase of 3 dB). A slider displays
the added value when you handle it.
Copy/Paste
You can copy all the parameters (inpatch, over-mute, channel mute,
delay, volume, gain, array-EQ, headroom and setup) of one NXAMP and
paste them to one or many NXAMPs. To do so:
1. Select an NXAMP (e.g. from the Groups & devices menu).
2. From the Control tab, tap on (copy).
3. When the copying operation is completed, select the NXAMP(s) to
paste parameters on.
4. From the Control tab, tap on (paste).
Undo/Redo
Every action can be undone, by pressing . An action sheet appears,
letting you the choice to undo the previous step, or redo the last undone
step. The undo action takes into account the number of channels and
devices on which the action to undo had been performed.
A Paste operation (see above) can be undone.
Undo/Redo is also available for the Setup tab.
Reset all
To reset all parameters of an NXAMP (inpatch, over-mute, channel mute,
delay, volume, gain, array-EQ, headroom), recall the FLAT setup (see
below).