Yokogawa AXFA14G/C - Manual (Page 60)

IM 01E20F12-01E 9-2
9. PARAMETER LISTS
T0901-2.EPS
Index Parameter Valid Range Initial Value Description
Write
Mode
36 DESCRIPTOR User definition text (a string) to describe the device within the
application. Auto
37 DEVICE_MESSAGE User definable MESSAGE (a string) to describe the device within the
application or in the plant. Auto
38 DEVICE_INSTAL_DATE Date of installation of the device. Auto
40 IDENT_NUMBER_
SELECTOR Each PROFIBUS-DP device shall have an Ident_Number provided
by the PNO. Auto 0: PROFILE ID
1: device-specific ID 1
41 HW_WRITE_PROTECTION This parameter is used in order to indicate the position of a write
blocking mechanism which protests all acyclic write access to all
writable parameters of a device. –
Yokogawa internal use. –
0: Unprotected
1: Protected 0
0 to 126 0
42-48 reserved by PNO
49 SOFT_DESC
This parameter is used in order to set or change the station address. O/S 50 SET_ADDRESS
0x00...0
(12 digits) This parameter is used in order to indicate the status of the function
block. (0x000000000000) Auto 51 FUNCTION_BLOCK_
STATUS
0: Disabled For testing alarms and warnings can be modified. Switch to enable
or disable alarm simulation.
When this parameter is set to enable and the hardware simulation
jumper is on, all of alarms and warnings in DIAGNOSIS_
EXTENSION can be modified with DIAGNOSIS_SIM_EXTENSION. Auto 52 DIAGNOSIS_SIM_MODE 0: Disabled
1: Enabled
0x00...0
(12 digits) Definision of supported DIAGNOSIS_EXTENSION information-bits.
For testing alarms and warnings can be modified.
When the hardware simulation jumper is on, DIAGNOSIS_SIM_
MODE is set to enable, and the bits are set to “on”, the arlarms
(or warnings) can be modified. (0x000000000000) Auto 53 DIAGNOSIS_SIM_
EXTENSION
View objects allow the following groups of physical block parameter
values to be read with one read request.
ST_REV, MODE_BLK, ALARM_SUM, DIAGNOSIS – 54 VIEW_PHYSICAL_BLOCK
39 Not used
35 FACTORY_RESET 0: No function
1: Factory Reset
2506: Warm start
2712: Reset Address
to “126”
0 Allows a manual restart to be initiated.
0: No
function.
1: Resetting device to the factory default.
2506: Warm start of the device.
All parameterization remains unchanged.
2712: Reset the bus address to “126”.
Auto