Yokogawa AXFA14G/C - Manual (Page 17)

IM 01E20F12-01E 4-3
4. CONFIGURATION
NOMINAL_SIZE:
Specifies the size of the flow tube.
NOMINAL_SIZE_UNITS:
Specifies the unit of the flow tube size.
LOW_MF:
Specifies the meter factor of low frequency side.
HIGH_MF:
Specifies the meter factor of high frequency side.
LOW_MF_EDF:
Specifies the meter factor of low frequency side under
enhanced dual frequency mode.
HIGH_MF_EDF:
Specifies the meter factor of high frequency side under
enhanced dual frequency mode.
VOLUME_FLOW_UNITS:
Units of VOLUME_FLOW are shown in Table 4.1
Table 4.1 VOLUME_FLOW_UNIT
d h min s
Ml/d(1355) Ml/h(1522) Ml/min(1521)
m3/d(1350) m3/h(1349) m3/min(1348) m3/s(1347)
kL/d(1520) kL/h(1519) kL/min(1518) kL/s(1523)
L/d(1354) L/h(1353) L/min(1352) L/s(1351)
cm3/d(1514) cm3/h(1513) cm3/min(1512) cm3/s(1511)
m/s(1061)
t/d(1329) t/h(1328) t/min(1327) t/s(1326)
kg/d(1325) kg/h(1324) kg/min(1323) kg/s(1322)
g/d(1321) g/h(1320) g/min(1319) g/s(1318)
kft3/d(1527) kCFH(1526) kCFM(1525) kCFS(1524)
ft3/d(1359) CFH(1358) CFM(1357) CFS(1356)
mft3/d(1531) mCFH(1530) mCFM(1529) mCFS(1528)
Mgal/d(1366) Mgal/h(1459) Mgal/min(1455) Mgal/s(1451)
kgal/d(1462) kgal/h(1458) kgal/min(1454) kgal/s(1450)
gal/d(1365) gal/h(1364) GPM(1363) gal/s(1362)
mgal/d(1461) mgal/h(1457) mgal/min(1453) mgal/s(1449)
kbbl/d(1493) kbbl/h(1489) kbbl/min(1485) kbbl/s(1481)
bbl/d(1374) bbl/h(1373) bbl/min(1372) bbl/s(1371)
mbbl/d(1492) mbbl/h(1488) mbbl/min(1484) mbbl/s(1480)
ubbl/d(1491) ubbl/h(1487) ubbl/min(1483) ubbl/s(1479)
kbbl/d(1534) kbbl/h(1533) kbbl/min(1532)
bbl/d(1538) bbl/h(1537) bbl/min(1536) bbl/s(1535)
mbbl/d(1542) mbbl/h(1541) mbbl/min(1540) mbbl/s(1539)
ubbl/min(1544) ubbl/s(1543)
ft/s(1067)
klb/d(1548) klb/h(1547) klb/min(1546) klb/s(1545)
lb/d(1333) lb/h(1332) lb/min(1331) lb/s(1330)
VOLUME_FLOW_FTIME:
Specifies output time constants. Setting range is 0.1 to
200sec. “3sec.” is factory set.
LOW_FLOW_CUTOFF:
Specifies low cut range for output. Setting range is 0 to
10%. “0%” is factory set. The larger absolute value
between Array1 and Array2 is used for the scale.