Yokogawa AXFA14G/C User Manual
Page 29

IM 01E20F12-01E
5-5
5. EXPLANATION OF BASIC ITEMS
(2) Bus Address change for DTM
A message as “The communication DTM sent abort” in
the DTM Works is appeared as shown in figure 5.3.5.
Click [OK] for this message window. A new DTM
Works window is established as shown in figure 5.3.6,
however, close this DTM Works window.
Figure 5.3.5
Message from DTM Works
Figure 5.3.6
New DTM Works window
Go back to the FieldMate window as shown in Figure
5.3.7 and confirm that the address is still no change.
Next, click the icon for “Update”. The FieldMate starts
to communicate with the AXF and the new address is
set after several seconds (Figure 5.3.8).
Click this icon as “Update”.
Figure 5.3.7
FieldMate window
Figure 5.3.8
New Bus Address was set
Change the parameter from [Out of Service (O/S)] to
[AUTO] again at [Target Mode] in the [Query Device
PB] menu and confirm that the parameter is changed to
[AUTO] at [Mode Block: Actual] at the same time by
referring to the Figure 5.3.1 to 5.3.3 when the bus
address change work was finished.
Figure 5.3.9
Mode Block: Actual confirmation
The procedure of the Bus Address setup was finished.