Yokogawa AXFA14G/C - Manual (Page 25)

IM 01E20F12-01E 5-1
5. EXPLANATION OF BASIC ITEMS
5. EXPLANATION OF BASIC ITEMS
5.1 Outline
This section describes basic parameter setting by use of
FieldMate R1.03 including easy setup and AXF display
of integral indicator.
The following sections describe how to adapt the
function and performance of the AXF to suit specific
applications because two or more devices are connected
to PROFIBUS PA, setting including the requirements
of all devices need to be determined. Practically, the
following steps must be taken.
Refer to Chapter 4 when the AXF is set parameters by
use of other engineering tools in each function block.
5.2 Basic Parameter Setting and
Changing
This section describes basic parameter setting and
changing with FieldMate R1.03. For detailed informa-
tion on FieldMate, refer to its User’s manual.
5.2.1 Explanation of Menu.
The DTM Works window is shown below.
Navigation tree
Identification area
Parameter set
application
Device
Figure 5.2.1 DTM Works
Identification area
This area contains information about the device that is
handled by the DTM. At online parameter, all param-
eters in this area must be handled as dynamic variables.
Parameter set application
This area displays the device parameters. Parameter
setting and changing are performed in this area.
If the mouse of PC moves to each parameter name, its
explanation is appeared.
Navigation tree
The navigation tree provides an overview of the
parameter settings. User can easily navigate the folders
and submenus using the tree view. The tree view is
similar to that of windows explorer. A submenu is
viewed by clicking a folder with the plus sign [+].
Clicking the minus sign [-] will close the submenu.
User can select an element by pushing the up or down
arrow key. The navigation tree for online parameters is
described in the following table.
IMPORTANT
• Before running the program, log-in to Windows
as an Administrator or as a user with adminis-
trative authority.
• When comm. DTM is connected to the PROFI-
BUS network with class 1 master running, set
the same busparameters of class 1 master.