Proface LT4300M - 5.7 Modular HMI + Control" - Manual (Page 20)

LT General Overview
20
Certifications and Standards
Introduction
Pro-face submitted this product for independent testing and qualification by third party listing
agencies. These agencies have certified this product as meeting the following standards.
For information on Standards and Regulations, such as certified models and certificates, see the
marking on the product or the following link:
http://www.pro-face.com/worldwide.html or product marking.
Agency Certifications for LT Unit
LT is manufactured in accordance with UL 508 and CSA C22.2 n ° 142 for Industrial Control
Equipment.
For use on a flat surface of a Type 1, Type 4X (indoor use only) enclosure.
Hazardous Substances
This product is a device for use in factory systems. When using this product in a system, the system
should comply with the following standards in regards to the installation environment and handling:
 WEEE, Directive 2012/19/EU
 RoHS, Directives 2011/65/EU
 RoHS China, Standard SJ/T 11363-2006
 REACH regulation EC 1907/2006
CE Markings
This product conforms to the necessary requirements of the following Directives for applying the
CE label:
 2006/95/EC Low Voltage Directive
 2004/108/EC EMC Directive
This conformity is based on compliance with IEC61131-2.
CAUTION
ENVIRONMENTAL HAZARDS TO THE EQUIPMENT
 Allow the device to reach the surrounding air temperature, not exceeding 50 ° C (122° F),
before turning the device on.
 Do not turn on the device if condensation has occurred inside the device. After it is completely
dry again, the device may be turned on.
 Do not expose the device to direct sunlight.
 Do not obstruct the vents in the device casing.
 Remove any dust from the device before turning it on.
 Ensure that the cable installation fasteners are not damaged. Replace them, if necessary.
 Mount the device into an enclosure that meets the IP65 level of protection.
Failure to follow these instructions can result in injury or equipment damage.