Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 43)

GP3000H Series Hardware Manual
2-14
2.3.7 Connecting the GP Unit
‹ Attachment
(1) Before connection, remove the cable’s connector cap and GP3000H connector cover. To remove the
cable’s connector cap, pull out the cable by holding the cable connector as shown.
(2) Insert the cable connector to the GP3000H cable connector until it clicks. Match the S points and insert
the cable connector, as shown below.
(3) Turn the cable connector lock ring to lock the connector, so that the small
U
mark (for LOCK) on the
lock ring is aligned with the small
V
mark on the cable connector.
• Always connect the connection device side first, and the GP side last. Failure to
observe this precaution may damage the RS-232C/RS-422/RS-485 circuitry.
• To disconnect this cable from the connector cap, be sure to hold the cable connector and pull it
out. If you hold other parts of this cable (lock ring, etc.), the cable cannot be disconnected.
• Be sure to insert the cable connector as shown. Failure to do so might result in damage to the
connector.
Pull out the cable by holding the cable connector.
connector cap
Match the S points and insert the cable
connector until it clicks.
Align the small U and V marks to lock the connector.
Lock Ring