Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 27)

GP3000H Series Hardware Manual
1-14
H: USB Host Interface
Complies with USB 1.1. Uses a “TYPE-A”
connector.
Power supply voltage: DC5V±5%,
Output current: 500 mA (max).
Connect to the transfer cable, storage device (USB
memory, CF Card reader), etc.
The maximum communication distance: 5 m.
I: CF Card Interface
Insert the CF Card in this slot.
J: DIP Switches
K: LAN Status LED
The LED turns on or off to indicate the current
status of the Ethernet transmission interface
(10BASE-T/ 100BASE-TX).
DIP
Switches
Function ON OFF Note
1
CF Card Startup Settings
(Controls unit startup from
the CF Card.)
Startup from CF
Card is enabled.
Startup from CF
Card is disabled.
CF Card with startup
data required.
2 *1
*1 When power supply is turned ON and DIP Switch 2 is ON, it starts with Transfer Mode.
Normally, set it to OFF.
Forced Transfer Mode
Forced Transfer
Mode: ON
Forced Transfer
Mode: OFF
-
3 Reserved - - Constantly OFF
4 CF Card access setting
CF Card access
enabled
CF Card access
disabled
-
• After inserting a CF Card, be sure to turn ON DIP Switch 4, and close the CF
Card cover before using the GP unit.
• Before removing the CF Card, turn OFF DIP Switch 4 first, and make sure that
the CF Card access LED turns off. If you remove the CF Card while the CF Card
is being accessed (while the LED is lit), it may result in data corruption.
LED Indicates
Green
ON
Data transmission available
Green
Flashing Data transmission in progress.
Green
OFF
No connection or subsequent
transmission failure
Orange
ON
During connection with 100BASE-
TX
Orange
OFF
During connection with 10BASE-T
or No connection
Top
G
CF Card Cover Open
F G H I
J, K
1 2 3 4
ON