Teledyne LeCroy CANbus TD and CANbus TDM - Operators Manual - Manual (Page 36)

CANbus Trigger, Decode, and Measure
36
CANbus-TD-TDM-OM-E RevB
In addition, some optional LeCroy programs add the capability to produce larger histograms and
trends of your measurement parameters. If you have this capability, then you can access it
through the Measurement Parameter setup dialog (the Px tab).
Pass/Fail Analysis with Measurement Parameters
Pass/Fail analysis using measurement parameters is simple to set up and powerful. For
instance, you can define a timing measurement, define the limits for the timing measurement,
and then run the oscilloscope in a Normal trigger mode, capturing thousands of measurement
events. Then, Pass/Fail can be used to save the waveform in the event of a Fail, or send an
email in the event of a fail.