Teledyne LeCroy IBTracer 4X - Users Manual Ver.2.30 - Manual (Page 27)

19
IBTracer 4X Protocol Analyzer User’s Manual CATC SW Version 2.3
Step 2
Power-on the IBTracer Analyzer.
Step 3 Connect the USB cable to the rear of the analyzer and to the personal
computer.
The host operating system detects the Analyzer and begins to install
the USB driver.
Note
When Windows prompts you for a file, browse to the CATC CD.
If this is a first time installation, the ctcupa10.sys (UPAS) and
ib4trcer.sys (USB) drivers must also be installed.
Installing the IBTracer Application Program
Run setup.exe from the IBTracer CD-ROM.
The CATC IBTracer Install Wizard automatically installs the necessary
files to the computer’s hard drive. IBTracer software is installed in the
C:\Program Files\CATC\IBTracer directory unless you specify otherwise.
Follow the installation instructions on your screen.
Installing IBTracer Software for the InfiniBand 1.1 Specification
IBTracer version 2.3 supports the new InfiniBand 1.1 specification. This
version is available for purchase as a special feature from CATC. Consult
the CATC website for further details.
www.catc.com
Both IBTracer 2.3 and IBTracer 2.2 can be installed on the same PC. If you
plan to install two version, install the version 2.2 first, then install version
2.3.
Version 2.3 will be installed in a separate directory called IBTracer
(spec1.1).
Either version can be run from the start menu, but only one version should
be run at a time.
To distinguish which version you are running, look at the titlebar at the top
of the window. The titlebar will show (spec 1.1) in version 2.3.
You can also see what version of software is running by opening the
"Help-About" box by selecting Help > About IBTracer.