Breaking a connection, Creating a connection, 12 verification scripts – Teledyne LeCroy IBTracer 4X - Users Manual Ver.2.30 User Manual
Page 135: Breaking a connection creating a connection, Verification scripts

127
IBTracer 4X Protocol Analyzer User’s Manual
CATC
SW Version 2.3
Unresolved Reliable Connections occur if the recording does not capture
key events in the traffic - for example, if a device is connected prior to
beginning the recording. The Resolve Reliable Connections dialog can let
you manually assign one half of a connection to another.
You can leave connections unresolved by clicking OK.
Breaking a Connection
To break a connection that you believe is incorrect, select it from the center
column, then click the button marked Break Connection.
Creating a Connection
To connect two halves of a connection, select an entry from the Rx column,
and then select an entry from the Tx column that you believe matches to it.
If the DLID and SLID values match, the Create Connection button will
become active. Click the button to make the connection.
10.12 Verification Scripts
IBTracer supports the use of verification scripts, a tool for performing
custom decodes and tests on traces that have already been created. A
vendor, for example, can record some traffic that might have
vendor-specific MADs and then afterwards use verification scripts to
decode the vendor MADs, or perform custom compliance test on the traffic,
or provide statistics on events not measured by Bus Utilization or Traffic
Summary.
For more information on Verification Scripts, please see the
Verification Script Engine User Manual available from CATC.
How to Run a Verification Script
CATC provides some sample scripts in the directory
CATC\IBTracer\Scripts\VFScripts which you can run to see how the
analyzer software handles them. These script files have a *.dec extension.
These files are provided so that you can modify them or use them as models
for new files.