Teledyne LeCroy IBTracer 4X - Users Manual Ver.2.30 - Manual (Page 24)

16
IBTracer 4X Protocol Analyzer User’s Manual CATC SW Version 2.3
3.5 PC Connection
Use the USB cable provided to connect the host computer to the UPAS.
• At least 20 MB hard disk space is required, plus additional memory for
recordings (as much as 2 Gbytes or more when recording a full buffer
size).
• Monitor resolution is at least 800x600 with thousands of colors.
3.6 InfiniBand Cable Connection
CATC provides two 1x-to-4x InfiniBand cables and one 4x InfiniBand
cable. The 1x-to-4x cables are actually 1x cables with 4x connectors. These
cables allow you to connect 1x devices to IBTracer 4x.
3.7 External Interface Breakout Board
The External Interface Breakout Board is an accessory that allows
convenient access to several potentially useful standard, LVTTL output and
input signals. It also offers a simple way to connect logic analyzers or other
tools to the IBTracer 4X Analyzer unit. Six ground pins and one 5-volt pin
are provided.
The Breakout Board connects via a cable to the Data In/Out connector
located on the rear of the analyzer box. Each signaling pin on the breakout
board is isolated by a 100
Ω series resistor.
Figure 3: Data In/Out Cable Connector
Pin-Outs for the Data In/Out Connector
The following table lists the pin-out and signal descriptions for the Data
In/Out connector. This pin-out is for a cable connector that connects to the
breakout board.