SecurityMan iCamDVR (after Dec. 2011 shipment) - Manual (Page 59)

59 | SecurityMan
Mode” and all 4 cameras will playback in four split screen,
the channel modes are illustrated below:
The default playback mode is Single Channel Mode
which display Camera 1. To change from Camera 1 to
other cameras, click on the “Single Channel Mode”
button and the following channel configuration window
will appear:
Select any one of the four channels from Channel Config-
uration Windows, please a check mark on “audio” if the
selected camera supports audio recording, and then click
“oK” to accept changes.
Click to select the four Channel Mode button to playback
all 4 channels at the same time and the following Channel
Configuration Window will appear:
Select any combination of the 4 channels or all 4 chan-
nels and select the audio channel that corresponds to the
camera audio setup to playback , then click “OK” to accept
changes and starts playback.
Control Buttons and functionality:
Play/Pause –– use to start playback and to pause
during playback.
Stop –– use to stop the playback.
Play Speed (Slow) –– use to play the playback 6
times slower than normal speed.
Play Speed (Fast) –– use to play the playback 4
times faster than normal speed.
one Channel Mode four Channel Mode
figure 92 - one Channel Select
figure 93 -four Channel Select