SecurityMan ZT-705 - Manual

2.4GHz Wireless Receiver User Guide (ZT-705)
1 x 2.4GHz Wireless Receiver 1 x 12V power AC adapter 1 x Remote Controller 1 x AV cable
Remote Controller
Package Contents
Receiving Frequency 2.4 GHz (4 CH)
Intermediate Frequency 480 MHz
Frequency Stabilization +/- 100KHz
Demodulation Mode FM
Antenna Directional
Local Leakage at Input Terminal <-55 dBm
Receiving Sensitivity
<-85 dBm
Video Output 1Vp-p@75 S/N>38dB
Audio Output 1Vp-p@600
* Only works with SecurityMan wireless cameras at frequencies of 2414, 2432, 2450, & 2468 MHz.
* Able to select any single camera or auto-loop/switch function
Power Supply 12V DC
Power Consumption Current 250mA
Operating Temperature -10˚C ~ +50˚C / +14˚F ~ +122˚F
Storage Temperature -40˚C ~ -85˚C / -40˚F ~ +185˚F
Operating Humidity 85%
Dimensions [W x L x H ] 5.9" x 4.2" x 7.3"
Weight 250g
Frequencies: CH-1 2,414MHz, CH-2 2,432MHz,
CH-3 2,450MHz, CH-4 2,468MHz
Specifications
Hardware Basics
Remote Control Button Function
1 2 3
4 5 6
7 8
+
CHANNEL REMOTE
Channels
Number
Lock/
Unlock Key
Channel
Down
Circulator
Setup Key Channel
Up
Receiver
AUDIO/R AUDIO/L VIDEO/R DC12V
Power Jack
(DC 12V, 300mA)
Video output
(Yellow)
Audio output
Right (White)
Audio output
Left (Red)
Antenna
IR signal
receiving
window
LED channel
display
Channels
switch/
circulator
A
B
For first
time use,
please
remove
the plastic
Press and
hold the
battery
bracket from
direction A,
and then pull
the bracket
out from
direction B
+ +
Install a
battery
with "+"
upwards
To reinstall the battery
Max 180˚
Max 90˚
Function
Channel
Mode
Button LCD Indicator on Receiver Function Button LCD Indicator on Receiver
1 4 ~ Display the input channel
Enable/
Disable
Mode
"d" means the remote controller
function is disabled.
"E" means the remote controller
function is enabled.
Channel
Mode
_
+ or Display the previous or next channel
Circulation
Mode
When is pressed once, it will
display a blinking "L".
Press the again, it will display
circulator setup running " ".
1 4 ~
Selective
Circulation
Mode
For example, you want to set channel sequence display on the TV/ Monitor
as Ch2 > Ch3 > Ch1 > Ch4. First press the once and "L" will blink on the
LCD display. Now input "2" from the remote, the number "2" will show on the
LCD, continue to input "3" > "1" > "4" and press again. The LCD will
display circulator setup running " ". And now the TV/Monitor will show the
channel sequence as Ch2 > Ch3 > Ch1 > Ch4.
When is pressed once, it will
display a blinking "L".
Select the channel sequence you
want to input and the number will
display and it will blink on the LCD
indicator, repeat until you are set.
Press the again, it will display
circulator setup running " ".
1