Ronan X96S MASS FLOW GAUGE - Manual (Page 64)

60
Configuration
Ronan ships the Mass Flow Gauge System with factory-default software settings. Those settings are
responsible for the information that initially appears on the status displays.
After installation at your site, you may need to reconfigure the system to fit your application. The goal is to
correlate the X96S output with your actual density readings. The list below summarizes the activities that
are detailed in the remainder of this chapter:
- Check the factory-default settings to be sure they are appropriate for your circumstances. IF NOT, make
the necessary changes and document those changes for future reference.
- Perform an initial calibration to correlate the X96S’s output to the actual process rate/density
- Document detector output counts at calibrated values to assist in troubleshooting. Also, record changes
you make to factory-default settings. Keep this information for future reference.