Ronan X96S MASS FLOW GAUGE - Manual (Page 11)

7
Configuration Operation
Density Filtering
Operation Density Filtering
Mass Flow Flow Rate Filter Type RC [1 st Order]
Density Empty Clamp Dyn Track [enable/disable]
Solids Setup Detector Fault [min/max cts] Sigma [number]
Flow Rate Temp Comp Fast TC [seconds]
Proc Temp Linearization Fast Counter [CPU scans]
Head Temp Scan Time [ms] Medium TC [seconds]
Display Totalizer Slow counter [CPU scans]
Remote Totalizer Mass Flow Slow TC [seconds]
PD Counter Noise Filter [0]
Alarms Mass Flow Units [units] Monitor [status]
Auto Reference Calc.Dry Solids
[enable/disable]
Hardware Low Range [number] Flow Rate Filter
Hart High Range [number]
System Type RC (1 st Order)
Density Dyn Track [enable/disable]
Sigma [number]
Dens. Units [unit] Fast TC [seconds]
Low Range [number] Fast Counter [CPU scans]
High Range [number] Medium TC [seconds]
Slow counter [CPU scans]
Solids Setup Slow TC [seconds]
Noise Filter [0]
Solids Method
[Fixed/Remote] Monitor [status]
Carrier [value]
Solids [value]
Empty Clamp
Solubility Factor [value]
Lo Solids Cap [read only] Empty Clamp [enable/disable]
Hi Solids Cap [read only] Off Time [seconds]
Solids Counts [count] Recovery Time [seconds]
Curr. Solids [value] Min counts [counts]
Min Solids [value] Max Counts [counts]
Max Solids [value]
Temp Comp
Flow Rate
Temp Comp [enable/disable]
Flow Rate Units [unit] Temp Units [units]
Low Range [number] A Coeff [number]
High Range [number] B Coeff [number]
Enter Temp [number]
Proc Temp Temp Auto Cap [enable/disable]
Last Ref. Temp.[read only]
Temp Units [units]
Low Range [number]
Linearization
High Range [number]
Linearize [enable/disable]
Head Temp Table Entry # [number]
Entry Used [yes/no]
Temp Units [C/F/R/Kelvin] Measured [value]
Low Range [number] Actual [value]
High Range [number] Clear Table
Figure 3-2 Configuration Menus