E-Mon E-PS-S-HV-RTU - Manual (Page 149)

Chapter 6 Device Control and Upgrading Upgrading Meter Firmware
PowerSmart Socket Power Quality Meter 149
2. Point to the firmware upgrade file, click Open, and
then confirm upgrading the meter.
3. When asked for the password, type the meter
password, and click OK.
4. Wait until Power Software completes downloading the
file. It takes about 9-10 minutes at 115,200 bps via a
serial port, or about 20 seconds via a USB port, to
download the file to the meter.
5. Wait about 10 seconds until the meter completes
burning firmware into the flash and reboots before any
further manipulating with the meter.
NOTES
1. When the meter reboots, the Ethernet and GPRS
networks are both restart, so communications may be
temporarily lost. You may need to wait a short
duration before Power Software restores a connection
with your meter.
2. If you are connected to the meter via a wireless GPRS
network, the meter will logout of the network and