Micromod MOD: 30ML Installation - Manual (Page 37)

MOD 30ML Multiloop Controller
MECHANICAL INSTALLATION
31
Mounting the Instrument:
Note: If I/O modules or a
memory module are to be
installed in the instrument, the
instrument must be removed
from its housing.
The wiring connections to the
instrument terminal blocks can
be done either before or after the
instrument is mounted.
Mount the instrument assembly
to the panel or the surface using
the three #10-32X1/2 screws
provided.
Re-attach the cable to the
connector on the instrument as
shown in the figure.
Note: The red stripe on the cable
should line up with the Pin 1 of
the connector. This pin is either
marked with the number 1 or with
a dot.
Ensure CPU
board and plug-
in I/O modules
(if any) are
visible from
this side of
housing
6
7
Ensure CPU
board and plug-
in I/O modules
(if any) are
visible from
this side of
housing
6
7
8
9
WARNING! Ensure red
stripe on cable lines up with
Pin 1 on connector
8
9
WARNING! Ensure red
stripe on cable lines up with
Pin 1 on connector