Magnum Venus Plastech Megaject RTM Pro Revison 7_0 - Manual (Page 24)

Megaject RTM Pro Manual – Revision 7.00 – 13
th
APRIL 2006
Figure 3.4 – Flush countdown screen
When the machine starts flushing, it will perform differently dependent on how the
machine has been configured.
If the machine is setup for single autosprue or no autosprue operation, then the
machine will perform a single flush.
If more than one autosprue is selected, the machine will perform a sequenced flush
operation.
Example 1 – Sprues 1 & 2 connected, initial & final flush enabled.
Sequence step Sprue 1 Sprue 2 Sprue 3 Sprue 4
1 FLUSH
2 RECHARGE SP3 PUMP
3 FLUSH
4 RECHARGE SP3 PUMP
5 FLUSH
6 RECHARGE SP3 PUMP
7 FLUSH
Example 2 – Sprues 2, 3 & 4 connected, initial flush disabled & final flush
enabled.
Sequence step Sprue 1 Sprue 2 Sprue 3 Sprue 4
1 FLUSH
2 RECHARGE SP3 PUMP
3 FLUSH
4 RECHARGE SP3 PUMP
5 FLUSH
6 RECHARGE SP3 PUMP
7 FLUSH
Table 3.0 – Flush sequencer examples