Magnum Venus Plastech Megaject RTM Pro Revison 7_0 User Manual
Page 12
Megaject RTM Pro Manual – Revision 7.00 – 13
th
APRIL 2006
NOTE: At the bottom left of the welcome screen, the current versions for the PAC
(Programmable Automation Controller, which is also referred to as a Programmable
Logic Controller (PLC)) and the Human Machine Interface (HMI) are shown. Please
refer to these versions when seeking technical assistance from Plastech.
NOTE: If any alarms are generated when the system is started, please refer to section
5. A common error is the “Emergency Stop” alarm, which will be triggered if the
safety circuit has not been reset, as described above, before the welcome screen has
been displayed on the HMI.
Figure 2.1 – Login screen
Press the LOGIN button to bring up the login screen, shown in Figure 2.2, and then
enter your user name and password. These details will have been supplied to you
when the machine was commissioned by a Plastech employee and must be entered
correctly before the machine can be operated. Version 1.00 of the screen software
supports only one level of security i.e. when the operator has logged on, all features
can be accessed.
To enter the username, press the User button, and enter the username on the keypad
followed by return. The keypad is shown in Figure 2.3. If you make an error while
entering the username, simply press the backspace key to delete the character that was
entered last. To navigate away from the screen, without making an entry, press the
ESC key. Repeat these steps for the password and then press return on the login
screen to attempt to log onto the machine.
Figure 2.2 – Login screen