Magnum Venus Plastech HIS INSTRUCTION MANUAL - Manual (Page 5)

- 5 - H.I.S. Instruction Manual
THINK SAFETY
STOP!
Before attempting to perform maintenance on the Magnum Venus Products
system:
1. Protective clothing should be worn at all times.
2. Safety glasses should be worn at all times
3. Maintenance should not be performed unless others are in attendance to render
assistance in case of an emergency.
4. Should any parts of the body come in contact with MEKP, the area should be
washed immediately with large amounts of clean water.
SHOULD EYES OR INTERNAL PARTS OF
BODY COME IN CONTACT WITH MEKP,
CONTACT A PHYSICIAN IMMEDIATELY.
CAUTION!
Before attempting to disassemble any portion of catalyst or resin system:
1. The air supply to powerhead of pump should be turned off.
2. The fluid pressure in the system should be relieved by triggering gun and allowing
fluid to drain into proper receptacle.
3. The air charge on both resin and catalyst accumulators should be released through
charging valves on top of accumulators.
4. Air to solvent tank should be turned off and the pressure relieved from tank (Only
after flushing gun clean of all resin and catalyst).
5. If pressure is trapped in system by a fluid block (plugged filter, set-up gun, etc.)
remove pressure by disconnecting resin line prior to suspected blockage.