Liquid Controls LCR Setup & Operation - Manual (Page 49)

49
Appendix C - Error Messages
DIAGNOSTIC MESSAGE LIST CONTINUED
DELIVERY END REQST
This message appears when a PRINT command has been sent to the LCR system to terminate a
delivery. PRINT can be activated from the Selector Switch, Lap Pad, or a Terminal. This is not an error
condition
POWER FAIL ERROR
This message appears when a delivery was ended due to a loss of input volt age. Check the power
supply and wiring to the LCR. Check the in-line fuse. See the troubleshooting section.
PRESET ERROR
This message appears when a flash memory error is detected during a delivery when accessing any of
the fields used by PRESETS. This includes GROSS PRESET amount, NET PRESET amount, S1
CLOSE VALUE
, remaining PRESET amounts, the PRESET type, or PRESET ALLOWED fields.
TERMINAL NOT CONNECTED
This message appears when a Terminal or Lap Pad is disconnected during a delivery . Check the
cables and connectors for broken wires and loose connections.
CHECK PRINTER AND CABLE
This message appears when the printer is not responding. This can be the result of a faulty data cable,
power cable, or LCR circuit board failure. The most common cause is that a ticket is not in place in the
printer. The Epson Slip printers have a built in photo eye to detect if a ticket is in position.
DATA ACCESS ERROR
This message appears when a flash memory error occurs.
DELIVERY TICKET PENDING
This message appears when a delivery has been terminated but a delivery ticket has not been completely
printed. When this occurs, it is assumed that the delivery is still active. No fields can be changed until
the delivery ticket has been entirely printed. Load a ticket into the printer and print the delivery ticket by
moving the Selector Switch to PRINT, or by pressing PRINT on the Lap Pad.
SHIFT TICKET PENDING
This message appears when a shift ticket is being printed. This is not an error condition.
FLOW ACTIVE
This message appears when a delivery has been initiated. This is not an error condition.
DELIVERY ACTIVE
This message appears when a delivery has been initiated. This is not an error condition.
GROSS PRESET ACTIVE
This message appears when a GROSS PRESET is active. The PRESET type must be set to GROSS
or BOTH and a desired amount entered in the GROSS PRESET field. This is not an error condition.