Hach-Lange SC 1000 - Manual (Page 80)

78
Advanced Operations
6.3 sc1000 SETUP menu
The sc1000 SETUP menu contains the main configuration settings for the sc1000
controller.
The sc1000 SETUP menu can include following items:
• OUTPUT SETUP
• CURRENT INPUTS
• RELAY
• WTOS
• NETWORK MODULES
• GSM-MODULE
• DEVICE MANAGEMENT
• DISPLAY SETTINGS
• BROWSER ACCESS
• STORAGE CARD
• SECURITY SETUP
• EMAIL, refer to DOC023.XX.90143 "sc1000 enhanced communications"
• LICENSE MANAGEMENT
• MODBUS TCP, refer to DOC023.XX.90143 "sc1000 enhanced communications"
The availability of the menu items depends on the installed internal plug-in expansion
cards or external DIN rail modules.
6.3.1 Output setup menu
Note: This menu appears only if an output card is installed in the sc1000 controller.
The content of the output setup menu depends on the selected use/working mode:
Linear/Control or PID Control. The current output card can be used with the output
current linearly dependent to a process value or with the output current working as a PID
controller.
LINEAR CONTROL
In this working mode the output current is linearly dependent to a process value after it
has been processed by the internal formula parser (if prompted).
PID CONTROL
In this working mode the current output module generates a current output which tries to
control the process value. The PID controller controls the process value to be equal to
the set point when a disturbance changes the value of the process value or a new set
point is set.
The output current can be in a working range of 0 – 20 mA or 4 – 20 mA. The highest output
current is 22 mA. If necessary adjust the output current with an offset and a correction
factor to enhance the accuracy. By default these two parameters are set to “0” (offset)
and “1” (correction factor).