Hach-Lange SC 1000 - Manual (Page 61)

59
Standard Operations
5.6 Calibrate the touch screen
During initial commissioning of the sc1000 controller, the touch screen calibration will be
automatically displayed. To configure the touch screen, follow the calibration points on
the screen. Make sure that the touch screen is calibrated to the appropriate device
(finger, stylus, etc.) that will be used by all operators. If the device is changed, it will be
necessary to recalibrate the screen.
To calibrate the touch screen after initial commissioning:
1. Select sc1000 SETUP, DISPLAY SETTINGS, TOUCH SCREEN CALIBRATION.
2. Follow the calibration points. When calibration is complete the Display Settings menu
is displayed.
5.7 Specify the displayed language
To specify the displayed language:
1. Select sc1000 SETUP, DISPLAY SETTINGS, LANGUAGE.
2. Use the ENTER button or press the selected language to enter the list box.
3. From the list box, select the language to display on the screen and select the ENTER
button to confirm the selection or select the CANCEL button.
5.8 Set the time and date
To set the time (24-h-format):
1. Select sc1000 SETUP, DISPLAY SETTINGS, DATE/TIME.
2. The keypad is displayed.
3. Enter the time using the keypad and press ENTER to confirm.
Figure 43 Keypad
1 BACK arrow button—Deletes the character previously
entered in the new position.
4 LEFT/RIGHT/UP/DOWN arrow button—Moves the cursor
position.
2 CANCEL button—Cancels the keypad input. 5 Keypad for entering regular numbers, characters,
punctuation, symbols and numerical sub- and
superscripts
3 ENTER button—Accepts the keypad input.