Analog Way Eikos LE - Manual (Page 9)

CAUTION:
All of the safety and operating instructions should be read before the product is operated and should
be maintained for further reference. Please follow all of the warnings on this product and its operating
instructions.
• WARNING: To prevent the risk of electric shock and fire, do not expose this device to rain,
humidity, intense heat sources (such as heaters and direct sunlight). Slots and openings in the
device are provided for ventilation and to avoid overheating. Make sure the device is never
placed near a textile surface that could block the openings. Also keep away from excessive dust,
vibrations and shocks.
• POWER: Only use the power supply indicated on the device of the power source. Devices
equipped with a grounding plug should only be used with a grounding type outlet. In no way
should this grounding be modified, avoided or suppressed.
• POWER CORD: The device is equipped with a main switch (On (I) /Off (O)). The Switch ON and
OFF is initiated by the main switch.
Caution: The power cord constitute the only mean to totaly disconnect the
equipment from the main power.
Apply the following guidelines :
- The equipment connected to the network must have a release system easily
accessible and located outside the unit.
- Unplug the power cord, do not pull on the power cord but always on the plug
itself.
- The outlet should always be near the device and easily accessible.
- Power supply cords should be routed so that they are not likely to be walked
on or pinched by items placed upon or against them.
If the power supply cord is damaged, unplug the device. Using the device with a damaged power
supply cord may expose your device to electric shocks or other hazards. Verify the condition of
the power supply cords once in a while. Contact your dealer or service center for replacement if
damaged.
• CONNECTIONS: All inputs and outputs (except for the power input) are TBTS defined under
EN60950.
• SERVICING: Do not attempt to service this product yourself by opening or removing covers and
screws since it may expose your device to electric shocks or other hazards. Refer all problems
to qualified service personnel.
• OPENINGS: Never push objects of any kind into this product through the openings. If liquids have
been spilled or objects have fallen into the device, unplug it immediately and have it checked by
a qualified technician.
HARDWARE INSTALLATION
SAFETY INSTRUCTIONS
2-1. SAFETY INSTRUCTIONS
7