Analog Way Smart MatriX LE - Manual

QUICK START GUIDE
What’s in the box
Quick install and setup
Thank you for choosing Analog Way and the Smart MatriX LE . By following these simple steps, you will be able to
setup and use your powerful 10x2 Scaled Matrix with Native Hi-Res. within minutes. Discover the Smart MatriX LE
extensive capabilities and intuitive interface while configuring your first show, and unleash your creativity for a new
experience in show and event management by Analog Way .
Smart MatriX LE - SMX100
1 x Smart MatriX LE (SMX100)
1 x Power supply cord.
2 x DVI male to HD15 female and DVI-D female breakout cable
1 x HD15 to 5 BNC cable
1 x Ethernet cross cable (for device update)
1 x Set of 3 audio 5-pin screw terminals
4 x Screws for handle removal (M4x12mm)
1 x RCS - Remote Control Software (PC only) *
1 x Quick Start Guide (PDF version) *
1 x User Manual (PDF version) *
* Download on our website:
www.analogway.com
WARNING !
If required, front handles of the device can be dismantled,
but with caution.
The original screws removed must not be reintroduced to
their location without handles in place.
Substantial damages can occur, including risk of elec-
tric shock from the mains voltage.
Only M4x12mm screws can be used.
(They are supplied with the unit)
Getting started:
You may wish to reset the unit to factory settings to get started.
Go to: Menu --> Control --> Default Values --> Yes .
1. Select the Output resolution that matches the native
resolution of your display. You will next be prompted to
choose enable follow mode if desired and output rate.
Menu --> Output 1 --> Output format --> 1024x768 -->
Internal Ref --> 60 Hz .
Do the same for Output 2.
2. InputscanbeconfiguredautomaticallyusingtheAuto-
Set All function.
Menu --> Intputs --> AutoSet All .
It will scan each input and detect the sync type that is
plugged in. You can still do an Autoset or manual setup
per input.
The Smart MatriX LE has 1 layer available called:
[BACKGROUND LIVE] .
3. To display a source, select the output # then select
the [BACKGROUND LIVE] layer (it will begin to blink)
then, select a source (it will also blink). Press [TAKE] to
transition your source from preview to program output.
There will always be a layer selected (blinking) and a source
selected (blinking) to the selected layer (blinking). To change the
contents of a different layer, simply select it.
4. To display a keyed Titling layer, you will need the RK300,
ARC200 or ORC50, select a PIP layer, select a source
into it, apply a keying effect on the the source to be able to
see it on your main output.
5. To clear the keyed layer or any other layer, select the layer
(it will blink) then, select [BLACK] . Press [TAKE] to remove
the layer from the program output.
*TIP* If you would like the Program and Preview to toggle/
flipflop during each TAKE, enable this feature by going to
Menu --> Control --> Preset Toggle .
Once enabled, everything on the Program output will become
the Preview during each TAKE.
See the next page which describes the button lighting color
code and other front panel features.
SMX100 can be used to display:
- Sources seamlessly switched in the Background Live lay-
er of each outputs.
- 1 Titling keyed layer and 1 Logo over the Background Live
layer.
IMPORTANT: Simply selecting a menu item will not set it to
that value. Be sure to press the ENTER button when para-
metering the menu items.