Analog Way Smart Vu - Manual

The Smart Vu front panel is comprised of several sections, each carefully labeled and self explanatory,
corresponding to all of the machine’s versatile functions.
The STANDBY button (1) will allow users to turn the device on and off once the main outlet switch (11) is
turned on. The menu screen (2), menu scroll knob (4), and Control section (3) will give users access to the
Smart Vu menu. The Layer Selection section (6) will allow users to select which layer the Smart Vu will work
on, while the Input Selection section (5), determines which of the 7 available input sources will be used in
that layer. The FREEZE button (7) allows users to take a snapshot of the displayed image. The TAKE button
(10) of the Smart Vu will display your Preview screen to the Main output (17). The EFFECT button (8) and
the PRESET button (9) are both shortcuts to Smart Vu menu functions (Layer Effects and Presets).
The rear panel of the Smart Vu will let you connect all of your input sources and outputs to the device. Plug
universal analog sources (14), DVI-I sources (15) and SD/HD-SDI sources (16) to your Smart Vu . Connect a
DVI or universal analog projection device to your Smart Vu video outputs (17), audio inputs and outputs (18
and 19), and a remote controller to the IP/LAN connector (13).
* NOTE * : the Preview Output of the Smart Vu does not come standard, it is available as an option (OPT-
MMS-Preview) to be ordered with the unit.
QUICK START GUIDE
What’s in the box
Smart Vu Overview
Thank you for choosing Analog Way and the Smart Vu . By following these simple steps, you should
be able to setup and use your powerfull scaler/switcher within minutes. Discover the Smart Vu
extensive capabilities and intuitive interface while configuring your first show, and unleash your
creativity for a new experience in show and event management by Analog Way .
Smart Vu - Ref. SVU300
1 x Smart Vu seamless scaler/switcher
1 x Power supply cord
1 x HD15 to 5 BNC cable
1 x Ethernet crossover cable
1 x Set of 3 audio 5-pin screw terminals
4 x M4x12mm screws
1 x RCS (PC only)*
1 x User manual (PDF version)*
1 x Quick Start Guide (PDF version)*
* Download on our website:
www.analogway.com
WARNING!
If required, front handles of the device can be dismantled,
but with caution.
The original screws removed must not be reintroduced to
their location without handles in place.
Substantial damages can occur, including risk of electric
shock from the mains voltage.
Only M4x12mm screws can be used.
(They are supplied with the unit)
2 4
1 2 4 3 5 6 7 8 9 10 8 9
3 5 6 7 1