AVTECH Room Alert 12ER Monitor (RA12E-TH1-RAS) - Manual (Page 7)

Room Alert 12E
AVTECH Software, Inc. 3
Introduction To Room Alert 12E
The Room Alert 12E is AVTECH’s mid-sized monitor that
has something for everyone. It boasts all the features of our
highest-end unit on a smaller scale and at a lower price. With the Room Alert 12E, AVTECH
brings you Temperature & Facilities Environment Monitoring… Made Easy.
The Room Alert 12E has one (1) internal temperature sensor and ten (10) external ports: three (3)
external digital, four (4) external switch, one (1) relay output, one (1) analog input, and one (1)
Light Tower & Relay Adapter port. Sensors are included for temperature and power.
Install your unit with minimal planning and less hassle.
9 Get up and running in minutes with easy “Plug and Play” setup.
9 Use Power over Ethernet to install even where no DC power is available.
9 Mount Room Alert 12E in a rack, on a wall, ceiling or table top.
Get access from anywhere over the web.
9 Configure, monitor and operate Room Alert 12E with its easy-to-use built-in web interface.
9 Significantly expand its functionality with AVTECH’s Device ManageR, the powerful
software bundled FREE with all Room Alert monitors.
9 Have the flexibility to monitor with any SNMP-enabled 3
rd
-party monitoring application.
Know immediately when physical conditions change.
9 Set alert thresholds for the built-in and bundled Digital Temperature Sensor from -40° to
185° F (-40° to 85° C).
9 Monitor the on/off status of a critical power source with the bundled external Power Sensor.
9 Alert multiple contacts on your team when thresholds are exceeded.
9 Receive alert notifications by email, email-to-SMS and more on a computer or mobile phone.
Expand your options as your needs evolve.
9 Extend your reach by adding 2 more external digital sensors up to 100 feet away and 4
external switch sensors up to 900!
9 Monitor an analog sensor using the built-in analog input port.
9 Automatically turn on/off electrical devices, such as air conditioners or generators, by using
the built-in relay output port and adding a Relay Switch Sensor (with adapter).
9 Use the Light Tower & Relay Adapter port to add a Light Tower or Relay Switch Sensor.
9 Explore your options further with your AVTECH Product Specialist.