AVTECH Room Alert 12ER Monitor (RA12E-TH1-RAS) - Manual (Page 25)

Room Alert 12E
AVTECH Software, Inc. 21
SNMP Trap Sending Configuration
You may configure your Room Alert 12E to send SNMP Traps in response to a change in alarm
state to up to three host systems running 3
rd
-party SNMP monitoring applications. Each host
system you enter in these fields will receive the same SNMP Traps simultaneously.
To configure your Room Alert to send SNMP Traps:
1. In “Trap Send IP 1,” enter the IP address of the host system that runs your 3 rd -party
SNMP monitoring application.
2. In “Trap Sent IP 2” and “Trap Send IP 3,” you may enter the IP addresses of other host
systems that run 3 rd -party SNMP monitoring applications, or leave the default, 0.0.0.
3. Click Accept Changes at the bottom of your screen to temporarily save your settings.
You may now navigate to another screen; however, if you close the web interface before
the next step, you will lose your changes.
4. Click Save Settings in the navigation bar to the left of your screen. Your Room Alert
12E will automatically reboot and commit your changes.
Sensors
You may configure alert thresholds for the internal temperature, external digital, external analog
and external switch sensors connected to your Room Alert 12E in this screen. Your Room Alert
12E sends alerts in response to changes in these alert thresholds.
For more information about AVTECH sensors and accessories,
please refer to the
Appendix at the back of this manual or visit the
Sensors and Accessories sections of AVTECH.com .
NOTE