AVTECH Room Alert 12ER Monitor (RA12E-TH1-RAS) - Manual (Page 29)

Room Alert 12E
AVTECH Software, Inc. 25
1. In “Sensor Label,” you may leave the default label, “Sensor 1,” or rename it to
something more descriptive, such as “Ext Temperature.”
2. The “Alarm On” fields automatically match the type of sensor you connect. In this
example, the “Alarm On” setting is Temperature.
3. Enter values in the “High” and “Low” field to set high and low thresholds. Your Room
Alert 12E will generate alerts in response to these temperatures.
4. Enter a value in the “Adjust” field to calibrate your digital sensor if its reading differs
from a known value at that location.
5. In “Use Alarm Profile,” which controls devices connected through the Light Tower &
Relay Adapter port, you may leave the default, “No Alarm,” or choose an Alarm Profile
from the drop-down menu.
6. Click Accept Changes at the bottom of your screen to temporarily save your settings.
You may now navigate to another screen; however, if you close the web interface before
the next step, you will lose your changes.
7. Click Save Settings in the navigation bar to the left of your screen. Your Room Alert
12E will automatically reboot and commit your changes.
If you have a Light Tower (any model) or Relay Switch Sensor
connected to your Room Alert via a Light Tower & Relay
Adapter, you may configure Alarm Profiles. Please refer to the
Alarm Options section in this manual for further information.
NOTE
TIP
The options in these fields vary slightly depending on the type of
digital sensor you connect.