AVTECH Room Alert 12ER Monitor (RA12E-TH1-RAS) - Manual (Page 10)

Room Alert 12E
6 AVTECH Software, Inc.
Back
Reset Button
A small push button resets Room Alert 12E to factory
default settings.
Light Tower & Relay Adapter Port
A standard RJ-11 jack connects a Light Tower &
Relay Adapter to your Room Alert 12E via a standard
RJ-11 (straight through) telephone cord.
Relay Output Port
A set of contacts connects any low-voltage device to
your Room Alert 12E via standard speaker wire.
Analog Input Port
A set of contacts connects any low-voltage analog
sensor to your Room Alert 12E via standard speaker
wire.
Switch Sensor Ports
Four (4) sets of dry contacts connect Room Alert 12E
to any AVTECH switch sensor or dry contact on a
device (e.g., HVAC, generator, pump, fan, etc.) via
standard speaker wire or low-voltage 2-wire cable.
Switch Sensor Port 1 is shown here.
For more information about AVTECH sensors and accessories,
please refer to the
Appendix at the back of this manual or visit the
Sensors and Accessories sections of AVTECH.com .
NOTE