AVTECH Room Alert 12ER Monitor (RA12E-TH1-RAS) - Manual (Page 20)

Room Alert 12E
16 AVTECH Software, Inc.
Ethernet Configuration
Typically, you may leave the “Ethernet Configuration” section at the defaults, which are shown
below, for immediate use of Room Alert 12E.
However, if you connect your Room Alert 12E to a managed switch that controls your network
traffic, you may need to change these settings:
1. In “MTU Size,” you may leave the default, 1024, or enter a value as low as 512.
2. You may uncheck “Auto Negotiate” and choose:
• For “Speed,” 100 Mpbs or 10 Mbps.
• For “Duplex,” “Full” or “Half.”
3. In “Gratuitous ARP Broadcasts,” you may leave the default, “Enabled,” or choose
“Disabled.”
4. Click Accept Changes at the bottom of your screen to temporarily save your settings.
You may now navigate to another screen; however, if you close the web interface before
the next step, you will lose your changes.
5. Click Save Settings in the navigation bar to the left of your screen. Your Room Alert
12E will automatically reboot and commit your changes.
SMTP Email
You may configure your Room Alert 12E to send alerts via email and email-to-SMS.
Navigate to Settings Æ SMTP Email to open the “Email Settings” screen.