AVTECH Room Alert 12ER Monitor (RA12E-TH1-RAS) - Manual (Page 15)

Room Alert 12E
AVTECH Software, Inc. 11
Current Sensor Status Bar
Below the Status tab is the “Current Sensor Status Bar,” where you may view basic information
about your Room Alert 12E and make temporary adjustments to the sensor display.
• You may find your Room Alert 12E’s name, current date & time, and MAC address
here.
• To determine if your Room Alert 12E’s firmware is current, you may click Room
Alert 12E vX.X.X at the right.
• To temporarily modify the refresh interval of the “Status” screen while viewing,
which is 60 seconds (i.e., every 1 minute) by default, you may enter a value in
seconds in the “Update Every” field. Click outside the field to temporarily commit the
change.
• To temporarily toggle the temperature scale between Fahrenheit (F) and Celsius (C),
click Fahrenheit or Celsius .
TIP
Your Room Alert 12E must be connected to the internet in order
to check firmware versions.
Refer to the Advanced section in this manual for instructions on
setting the default status page refresh rate and temperature
scale for Room Alert 12E.
NOTE