Alpha Technologies AlphaNet IDH4 for XM2 and XM2-300HP Series - Technical Manual - Manual (Page 7)

7 746-257-B2-001, Rev. B (01/2014)
Safety Notes
Review the drawings and illustrations contained in this manual before proceeding. If there are any questions regarding
the safe installation or operation of the system, contact Alpha Technologies or the nearest Alpha representative. Save this
document for future reference.
To reduce the risk of injury or death and to ensure the continued safe operation of this product, the following symbols have
been placed throughout this manual. Where these symbols appear, use extra care and attention.
The use of ATTENTION indicates specific regulatory/code requirements that may affect the placement of
equipment and /or installation procedures.
ATTENTION:
A NOTE provides additional information to help complete a specific task or procedure.
NOTE:
WARNING presents safety information to PREVENT INJURY OR DEATH to the technician
or user.
WARNING!
The use of CAUTION indicates safety information intended to PREVENT DAMAGE to material or
equipment.
CAUTION!
Tables
Table 2-1, LEDs and Indications ....................................................................................................................................................12
Table 3-1, Modem Community String Parameters .........................................................................................................................14
Table 3-2, Trap Destination Addresses ..........................................................................................................................................15
Table 3-3, Changing Default idhdoc04.cfg Download Settings ......................................................................................................17
Table 3-4, Transponder Communications Parameters ...................................................................................................................18
Table 5-1, Modem Firmware Upgrade SNMP Parameters .............................................................................................................40
Table 6-1, SCTE-HMS MIB Files ....................................................................................................................................................42
Table 6-2, Binary to Hex Conversions for Alarm Settings ..............................................................................................................43
Table 6-3, Recommended Settings for IDH4 Series Analog Alarms .............................................................................................44
Table 6-4, Recommended Settings for IDH4L Analog Alarms .......................................................................................................44
Table 6-5, Recommended Settings for Discrete Alarms ................................................................................................................45
Table 6-6, SNMP Alarm Trap Varbinds and Explanations ..............................................................................................................47
Table 6-7, XM2 Major and Minor Alarms ........................................................................................................................................48
Table 6-8, Alpha MIB Hierarchy ......................................................................................................................................................50
Table 7-1, Environmental Control MIBs ..........................................................................................................................................61
Table 7-1, Environmental Control MIBs, continued ........................................................................................................................62
Table 7-2, OID Values for Battery Heater Mat Controller ...............................................................................................................63
Table 7-3, SNMP MIB Points for Battery Heater Mat Controller .....................................................................................................63
Table 11-1, Single IP Mode versus Dual IP Mode .................................................................................................................76
Table 11-2, Enabling Dual IP mode ......................................................................................................................................78
Table 11-3, CPE Communications Module IP Settings ........................................................................................................78
Table 11-4, Download Options .............................................................................................................................................80