0 web interface – Alpha Technologies AlphaNet IDH4 for XM2 and XM2-300HP Series - Technical Manual User Manual

Page 29

746-257-B2-001, Rev. B (01/2014)

4.0 Web Interface

4.8

Setting the I/O Controller via the Web Page

Settings for the Tamper Switch and I/O Controller may be made by accessing the the I/O - Environment

page from the

Advanced Configuration drop down list. The Tamper Switch polarity may be changed

by clicking on the preferred Tamper Switch polarity button. The I/O Controller section provides a user

interface to select the type of device that will be connected and monitored via the ENV connector of the

transponder. An example of such a device would be the battery heater mat controller.

Fig. 4-15, Advanced I/O Controller Status Screen

(data values shown for illustration purposes only)