beautypg.com

0 upgrading firmware, 3 upgrading manually by setting snmp parameters, 4 upgrading via the docsis configuration file – Alpha Technologies AlphaNet IDH4 for XM2 and XM2-300HP Series - Technical Manual User Manual

Page 41

background image

41

746-257-B2-001, Rev. B (01/2014)

5.1.3 Upgrading Manually by Setting SNMP Parameters

1. Acquire the firmware and CVC files for your IDH4 Series from Alpha Technologies.
2. Import the CVC into the modem’s DOCSIS Configuration File (to create a Configuration File,

see

Section 3.2).

3. Set the following MIB parameters using an SNMP MIB browser. For additional information

regarding the SNMP MIB parameters, refer to the table in

Section 5.1.2., "Modem Firmware

Upgrade SNMP Parameters".

5.0 Upgrading Firmware

Parameter

Value

docsDevSwServer
OID: 1.3.6.1.2.1.69.1.3.1.0

IP Address of TFTP server

docsDevSwFilename
OID: 1.3.6.1.2.1.69.1.3.2.0

Firmware filename

docsDevSwAdminStatus
OID: 1.3.6.1.2.1.69.1.3.3.0

1

The firmware upgrade will begin immediately. Monitor the upgrade status with the

docsDevSwOperStatus MIB parameter, and verify the firmware version with the

docsDevSwCurrentVers MIB parameter (refer to

Table 5-1, "Modem Firmware Upgrade SNMP

Parameters"). Once the firmware has been upgraded, the modem will automatically run the new

version.

5.1.4 Upgrading via the DOCSIS Configuration File

IDH4 Series firmware can be automatically upgraded using the DOCSIS Configuration File

by adding the following docsDevSoftware SNMP parameters and the manufacturer’s Code

Verification Certificate (CVC).

Parameter

Value

docsDevSwServer

OID: 1.3.6.1.2.1.69.1.3.1.0

IP Address of TFTP server

docsDevSwFilename

OID: 1.3.6.1.2.1.69.1.3.2.0

Firmware filename

docsDevSwAdminStatus

OID: 1.3.6.1.2.1.69.1.3.3.0

2

Manufacturer CVC

TLV:32

The CVC file for the IDH4 Series

The firmware will be upgraded on the next reboot. Monitor the upgrade status with

the docsDevSwOperStatus MIB parameter, and verify the firmware version with the

docsDevSwCurrentVers MIB parameter (refer to

Table 5-1, "Modem Firmware Upgrade SNMP

Parameters"). Once the firmware has been upgraded, the modem will automatically run the new

version.