beautypg.com

0 network configuration, 2 setting snmp trap destination addresses – Alpha Technologies AlphaNet IDH4 for XM2 and XM2-300HP Series - Technical Manual User Manual

Page 15

background image

15

746-257-B2-001, Rev. B (01/2014)

3.2

The DOCSIS Configuration File

3.2.2 Setting SNMP Trap Destination Addresses

Set the SNMP Trap Destination addresses via the DOCSIS Configuration File by including the

following SNMP parameters:

3.0 Network Configuration

MIB Parameter

Object ID

Description

Value

docsDevNmAccessIP

1.3.6.1.2.1.69.1.2.1.2.X

IP address of trap destination, e.g.

NMS server

e.g. 10.20.30.40

docsDevNmAccessIpMask

1.3.6.1.2.1.69.1.2.1.3.X

Must be set to 255.255.255.255 per

RFC 4639

255.255.255.255

docsDevNmAccessCom-

munity

1.3.6.1.2.1.69.1.2.1.4.X

Community string used by NMS to

query transponder

alphanumeric string

docsDevNmAccessControl

1.3.6.1.2.1.69.1.2.1.5.X

Level of SNMP access to IDH4

Series from IP address specified in

docsDevNmAccessIpMask

4= Read/Only plus Trap

5= Read/Write plus Trap

6= Trap only, no SNMP access

docsDevNmAccessInter-

faces

1.3.6.1.2.1.69.1.2.1.6.X

Specifies the set of interfaces from

which requests from this NMS will be

accepted

0x40 : Cable interface (typical)

0x80 : Ethernet interface

0xC0 or 0x00 : Both interfaces

docsDevNmAccessStatus

1.3.6.1.2.1.69.1.2.1.7.X

Controls and reflects the status of

rows in this table

4

Table 3-2, Trap Destination Addresses

Note: X denotes the index of the SNMP entry

NOTE:
As an alternative to the docsDevNmAccessTable, SNMP Trap Destination Addresses may be set through the

IDH4 proprietary MIB atiMgmtSnmpTrapTable (OID: 1.3.6.1.4.1.926.1.3.1.1) using an SNMP MIB Browser

or as an entry in the Proprietary Configuration File (see

Section 3.2.4, Proprietary Configuration File

'idhdoc04.cfg').