ABUS FUAA10021 Secvest IP Basic Set Operating instructions - Manual (Page 76)

17 Resetting an alarm
75
17. Resetting an alarm
The control panel is activated and an alarm was triggered:
• Via the web server:
Press the “Deactivate” button.
• Via a wireless remote control:
Press the “Deactivate” button on your remote
control to reset an existing alarm.
The control panel is not activated and an alarm was triggered:
• Via the web server:
Press the alarm button to reset the existing
alarm.
• Via a wireless remote control:
In order to reset an alarm using a wireless
remote control, the system must be armed
and then disarmed:
(1) “Activate” button:
o If the detector is still in the triggered
state, the alarm panel beeps eight
times to signal that it cannot be
armed.
o If the detector is no longer in the
triggered state, the alarm panel
beeps twice and arms itself.
(2) “Deactivate” button: The existing alarm
is reset and the control panel is in the
disarmed state.
(3) All alarms are reset.
After an alarm is issued, we recommend that you check the status of the
control panel on the web server or in the Secvest IP app.
(1)
(2)