ABUS FUAA10021 Secvest IP Basic Set Operating instructions - Manual (Page 17)

11 Labelling the Secvest IP
16
11. Labelling the Secvest IP
We recommend using the editable PDF on the supplied CD for labelling your Secvest
IP, or downloading the PDF for the corresponding product from our website. Labelling
the device is very simple. Enter your individual component settings in the PDF and
print it out. Insert the cut-out label into the corresponding gap on the inner side of the
cover.
We recommend using common, easy-to-understand abbreviations for the
detector type (e.g. MC = magnetic contact, MD = motion detector, SD =
smoke detector, VD = vibration detector, GD = glass breakage detector, FD =
flood detector).
Next, describe the location where the detector is found. This helps to identify
the detector quickly and easily in the event of malfunctions (e.g. empty
battery). Remember that the name must correspond to the actual
programming.
12. Putting into operation
Connect the alarm centre directly to your computer using a LAN (cross-over) cable,
or connect it to your network using a LAN cable. The factory-set IP address on the
alarm centre is 192.168.0.50.
4 Detector / Zone 1
3 Detector / Zone 1
2 Detector / Zone 1
1 Detector / Zone 1
Operating unit 3
Operating unit 2
Operating unit 1
5 Detector / Zone 2
6 Detector / Zone 2
7 Detector / Zone 2
8 Detector / Zone 3
9 Detector / Zone 3
10 Detector / Zone 3
11 Detector / Zone 3