ABUS FUAA10021 Secvest IP Basic Set Operating instructions - Manual (Page 69)

15 Teaching the wireless components
68
When you are finished, press ESC/DEL once. Pressing any other buttons has no
effect on the alarm centre at this point. The bottom LED lights up again permanently.
The main menu is accessed again.
15.2 Menu 2 – Deleting the components
Press SELECT until the second LED from the bottom lights up.
Press SET once to access menu 2.
The LED of a channel with a trained component lights up. Press SELECT repeatedly
until the desired channel lights up. Empty channels are indicated by a flashing LED. If
the LED of the desired channel lights up, press (beeps once) and hold down
ESC/DEL (about 4 seconds) until the alarm centre beeps twice and the channel LED
flashes. The component has been deleted. Repeat this as required to delete all the
corresponding components.
When you are finished, press ESC/DEL once. Pressing any other buttons has no
effect on the alarm centre at this point. The bottom LED lights up again permanently.
The main menu is accessed again and LED 2 lights up again.
15.3 Menu 3 – Selecting the channel settings (channel mode)
Explanation:
A detector is triggered (e.g. window is opened) and sends a status notification
to the alarm centre. If the window is closed again, then the detector sends
another notification of the changed status (closed) to the alarm centre.
If the corresponding channel is activated (detector triggered), then the zone is
also opened. If the channel is deactivated (detector inactive) then the zone is
also closed (providing all other detectors in this zone are also closed).
Some detectors (e.g. wireless panic alarms) do not send a new notification to
the alarm centre after becoming inactive. Resetting of the channel must be
made automatically in the alarm centre for these detectors. In order for this to
be made automatically, the channel attribute for these detectors must be set
to “Impulse”.
Press SELECT until the third LED from the bottom lights up. Press SET once to
access menu 3. The alarm centre beeps twice and the LED shows the first occupied
channel.
Press SELECT until the LED on the channel to be set lights up. Now press SET – the
alarm centre beeps twice again. The LED now indicates the selected setting for the
channel:
• “Impulse” is selected when the LED flashes.
• “Permanent” is selected when the LED lights up permanently.
Press SELECT to change the settings. The LED now indicates the selected setting.
Press SET again to confirm the changes. The alarm centre beeps twice again and
the LED shows the selected channel.
Repeat this process to make the settings for all components.