ABUS FUAA10021 Secvest IP Basic Set Operating instructions User Manual
Page 74

15 Teaching the wireless components
73
15.6 Menu 6 – Not in use
Option: Switching the display
(supervision monitoring displayed on LEDs: yes/no)
15.7 Menu 7 – External siren behaviour
In this menu, the type of signal from the external siren can be defined.
Press SELECT until the seventh LED from the bottom lights up.
Press the SET button once to go to menu 7.
The central alarm beeps briefly and LED 7 can show the following statuses:
OFF
The external siren does not have a signalling and alarm
function
Note: in this case, CON 3 does not have a function.
ON
permanent External siren function is activated, without any
acknowledgement flash or sound
Flashing
1Hz
External siren function is activated, with acknowledgement
flash and no sound
Flashing
5Hz
External siren function is activated, with acknowledgement
flash and sound
If you want to change the status, press SET repeatedly until you reach the required
mode.
To exit programming mode, press ESC/DEL until the alarm centre starts to beep
(about once per second). Close the housing or press and hold down the cover
tamper contact (SW4 (B), underneath ESC/DEL) for about 4 seconds until it beeps
twice. The data is saved in an EEPROM.
15.8 Menu 8 – Setting the default factory settings
Press SELECT until the eighth LED from the bottom lights up.
Press SET once to access menu 8.
All blue LEDs start flashing. This signals that the wireless module is ready to reset
itself to the factory settings.
Press and hold down the ESC/DEL button for about 4 seconds until the flashing
stops and the alarm centre beeps twice. The factory settings are now restored.
The main menu is accessed again.
To exit programming mode, press ESC/DEL until the alarm centre starts to beep
(about once per second). Close the housing or press and hold down the cover
tamper contact (SW4, underneath ESC/DEL) for about 4 seconds until it beeps twice.
The data is saved in an EEPROM.