ABUS FUAA10021 Secvest IP Basic Set Operating instructions - Manual (Page 11)

9 Installation of the backup battery (backup power supply)
10
6. Fasten the 13.8 V cable and LAN cable to the appropriate tension relief using the
supplied cable clips.
7. Fix the housing to the wall.
8. Make sure the spring of the wall tamper switch (A) is positioned correctly.
9. Make the appropriate settings on the web server.
10. Train the wireless components.
11. After training, replace the housing cover and tighten the cover screw.
9. Installation of the backup battery (backup power supply)
1. Disconnect the alarm centre from the power
supply.
2. Connect the supplied cable for the battery to
the IP module.
Red is the positive terminal and black is the
negative terminal. See the installation section
for more details.
3. Connect the battery correctly.
4. Insert the battery into the appropriate battery
clip and close the housing. See the installation
section for more details.
Trained wireless components and
programming are not lost in the event of a
power failure.
BT2020
backup battery