ABUS FUAA10021 Secvest IP Basic Set Operating instructions - Manual (Page 7)

5 Important safety information
6
• The device must not be exposed to strong variations in temperature, as this can
lead to condensation and electrical short circuits.
• The device must not be exposed to excessive jolts or vibrations.
5.7 Care and maintenance
Maintenance is necessary if the device has been damaged. This includes damage to
the plug, mains cable and housing, penetration of the interior by liquids or foreign
objects, exposure to rain or moisture or when the device does not work properly or
has fallen.
• Disconnect the device from the mains power supply before maintenance (e.g.
cleaning).
• If smoke develops or unusual noises or odours are detected, then pull the mains
plug from the socket immediately and remove the backup battery. In such cases,
the device should not be used until it has been inspected by a qualified
technician.
• Clean the device housing with a damp cloth.
• Do not use solvents, white spirit or thinners as these can damage the surface of
the device.
• Do not use any of the following substances:
Salt water, insecticides, solvents containing chlorine or acids (ammonium
chloride) or scouring powder.
• Gently rub the surface with a cotton cloth until it is completely dry.
5.8 Accessories
• Only connect devices that are suitable for the intended purpose. Otherwise,
hazardous situations or damage to the device can occur.
5.9 Putting into operation
• Observe all safety and operating instructions before putting the device into
operation for the first time.
• Only open the housing during installation and when training the wireless
components.
Warning
If in doubt, have a specialist technician carry out assembly, installation
and connection of the device.
Improper or unprofessional work on the mains power supply puts both
you and other persons at risk.