ABUS AZ6302 Terxon GSM dialer - Manual (Page 97)

97
Off: 4 low-pitch tones
6. After you have made your selection, you can continue with other
commands or terminate the connection by pressing the # key.
11.3.2.2 Listen Active / Speech Active
Using this function, you can listen into the device using the loudspeaker and
speak into it through the microphone by pressing 0.
6. Establish a connection to the GSM dialler.
7. Press
the *3 key on your telephone to listen to the installation site.
8. Press the 3 key to switch between Listen and Speech modes. You
can also switch modes by pressing .
9. You can cancel the Listen and Speech modes by pressing 0.
10. After you have made your selection, you can continue with other
commands or terminate the connection by pressing the # key.
11.3.2.3 Test Triggers
You can start a GSM dialer dial procedure by triggering the inputs 1-8.
4. Establish a connection to the GSM dialler.
5. Press
*8, then a number from 1-8 corresponding to the trigger being
tested.
6. The device then terminates remote access and calls up the allocated
contacts depending on the trigger.
11.3.2.4 Contact management
Using this function, you can enter or change the contact details (1-10) using
the telephone keypad.
6. Establish a connection to the GSM dialler.
7. Press
*7, then a number from 1-0 (0=10) corresponding to the contact
being edited.
8. Enter the telephone number twice, each with a # at the end. For
example: Allocation of number 123456 to contact 3 = *73
123456#123456#.