Extron Electronics PowerCage FOX Tx_Rx DVI Plus User Guide - Manual (Page 9)

System Compatibility
The fiber optic signal output from a PowerCage FOX Tx DVI Plus transmitter can be received
only by a PowerCage FOX Rx DVI Plus or FOXBOX Rx DVI Plus receiver.
The fiber optic signals from all other units are interchangeably compatible between VGA
and DVI units, Plus and non-Plus units, and PowerCage FOX, FOXBOX, and FOX 500 units as
shown in the following table.
Receiver Compatible transmitters
PowerCage FOX Rx VGA PowerCage FOX Tx VGA
PowerCage FOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOXBOX Tx DVI (non-Plus)
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
PowerCage FOX Rx DVI Plus PowerCage FOX Tx DVI Plus
PowerCage Tx DVI (non-Plus)
PowerCage FOX Tx VGA
FOXBOX Tx DVI Plus
FOXBOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
PowerCage FOX Rx DVI (non Plus) PowerCage FOX Tx DVI (non-Plus)
PowerCage FOX Tx VGA
FOXBOX Tx DVI (non-Plus)
FOXBOX Tx VGA
FOX 500 Tx (VGA)
FOX 500 Tx DVI
FOX 500 DA6
NOTES: • The PowerCage FOX units are fully compatible with all Extron
PowerCage FOX, FOXBOX, and FOX 500 products and a variety of other fiber
optic products. Those other products are identified where appropriate, but
not specifically described in this manual.
• The PowerCage FOX DVI does not support the transmission of signals with
High-bandwidth Digital Content Protection (HDCP).
PowerCage FOX DVI and PowerCage FOX VGA • Introduction 4