Extron Electronics PowerCage FOX Tx_Rx DVI Plus User Guide - Manual (Page 31)

2. Select the Com port to which your transmitter or receiver is connected. Click OK.
The FOX Extender program window appears (see figure 16).
Figure 16. FOX Extender Program Window
NOTE: Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for serial
command transmission. However, if you connect only one fiber optic cable,
there will be reduced control program functionality on the Rx unit. For full
functionality, install both fiber optic cables and leave the PowerCage FOX
receiver in normal mode (via an
SIS command for the PowerCage FOX Rx
receiver).
PowerCage FOX DVI and PowerCage FOX VGA • Remote Control 26