Extron Electronics PowerCage FOX Tx_Rx DVI Plus User Guide - Manual (Page 28)

Command/response table for SIS commands (continued)
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Audio mute
Mute the audio 1Z Amt1 ] Silence the audio output of the receiver.
Unmute the audio 0Z Amt0 ] The receiver outputs audio.
Show audio mute statue Z X!] Audio mute status is X! .
Auto memory
Disable auto memory 55*0# Img0 ]
Enable auto memory 55*1# Img1 ]
Show auto memory status 55# X!]
Auto Image™
Trigger Auto Image 55*2# Img ]
Test pattern
NOTE: You must have a video input connected and the transmitter-Tx-to-receiver-Rx fiber cable connected for the receiver to output a
selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power is removed.
Output Color Bars 1J Tst1 ] Set the receiver to output the Color Bars test pattern.
Output grayscale 2J Tst2 ] Set the receiver to output the grayscale test pattern.
Output alternating pixels 3J Tst3 ] Set the receiver to output the alternating pixels test
pattern.
Turn test pattern off 0J Tst4 ] Set the receiver to output the input video (no test
pattern is selected).
Show test pattern status J X1&]
Disable and enable return link and daisy chain
NOTE: The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the
receiver is connect to any of outputs 2 through 6 on the DA.
Disable return link 66*0*0# Rle*0*0 ] Disable link 2.
Enable return link to
transmitter 66*0*1# Rle*0*1 ] Enable link 2 (default setting).
Enable daisy chain 66*0*2# Rle*0*2 ] Enable receiver daisy chain mode.
Show return link and daisy
chain status 66*0# 0* X1*]
Video delay
NOTES: • The Set Video Delay command delays all analog, video, and sync video planes. This can help monitors sync correctly during an
input rate change.
• Only video is delayed. Audio is not delayed.
Set video delay 3* Y1! # Dly X2)] Delay video by an interval of Y1! .
Example: 3*3# Dly3 ] Delay video by an interval of 0.75 seconds
(3 x 0.25 seconds).
Show video delay 3# X2)]
NOTE: X! = Mute and auto memory status 0 = off 1 = on
X1& = Test pattern 0 = none 2 = grayscale
1 = Color Bars 3 = alternating pixels
X1* = Rx link and daisy chain enable 0 = disable 1 = return link enable 2 = daisy chain enable
X2) = Video delay 0 = 0 second
(0 plus six steps at 0.25 seconds per step) 1 = 0.25 second 4 = 1.0 second
2 = 0.5 second 5 = 1.25 second
3 = 0.75 second 6 = 1.5 second (default)
PowerCage FOX DVI and PowerCage FOX VGA • Remote Control 23