Extron Electronics MKP 2000 - Manual (Page 5)

MKP 2000 Remote Control Panel • Quick Start Guide
Quick Start Guide — MKP 2000, cont’d
MKP 2000 Remote Control Panel • Table of Contents
Chapter 1 • Introduction .......................................................... 1-1
About the MKP 2000 Remote Control Panel ........... 1-2
RS-232 connection to the switcher ....................................... 1-3
Ethernet connection to the switcher ................................... 1-3
Application diagram .............................................................. 1-3
Chapter 2 • Installation ............................................................. 2-1
MKP Installation Overview ............................................... 2-2
UL Requirements for Wall Box Installation ............. 2-3
Installation Procedures ....................................................... 2-3
Preparing the site and installing the mounting bracket
(mud ring) or wall box ........................................................... 2-4
Mounting the MKP to the mounting bracket (mud ring)
or wall box ............................................................................. 2-7
Rear Panel and Side Panel Connections .................... 2-8
Control connections ............................................................ 2-10
RS-232 cable termination .............................................. 2-11
TP cable termination ..................................................... 2-12
Power supply wiring ............................................................ 2-14
Chapter 3 • Local Operation .................................................. 3-1
Front Panel Controls and Indications ......................... 3-2
Front Panel Operations ....................................................... 3-3
Creating a tie ......................................................................... 3-3
Deselecting a tie .............................................................. 3-4
Viewing the last input or output tied from the MKP ......... 3-4
Viewing and configuring the IP and MKP setup
parameters ............................................................................. 3-4
Host control port setting and pass-through
communications ............................................................... 3-8
Control panel security lockout (executive mode) ................ 3-8
Rear Panel Resets .................................................................. 3-9
Performing soft resets ........................................................... 3-9
Performing a hard reset ...................................................... 3-10
Chapter 4 • SIS™ Operation ................................................... 4-1
RS-232 Links .............................................................................. 4-2
Routing matrix switcher commands ..................................... 4-2
Ethernet Link ........................................................................... 4-3
Default IP address .................................................................. 4-3
Table of Contents
QS-2
Step 10
Program the control panel with the size of the connected switcher .
See “System Settings page” in chapter 5, “HTML Operation.”
Step 11
Use the control panel to select inputs and outputs . See “Front Panel
Operations” in chapter 3, “Local Operation.”
i