Extron Electronics MS9200P - Manual (Page 81)

HD Player Chapter 12: Remote Control Protocols
81 Rev. 6.8
Loopoff
Turn off the loop flag for the requested channel.
The Player will respond with:
OK or ERROR
System/Status Commands
Shutdown
Shut the Player system down.
The player doesn’t send a response to this command.
Reboot
Reboot the HD Player.
The player doesn’t send a response to this command.
Getstate
Request the status of certain parameters for a specific player (Channel)
The Player will respond with:
Statetc 1 “00:00:00:00” (“current timecode”)
Statefile 1 “clip” “ (current clip”)
Stateplay 1 “status” (“playing”, “paused”, “stopped”)
Timecode Commands
Tcgenerate
Turns the timecode generator on and sends the timecode hh:mm:ss:ff out as a jam sync.
The Player will respond with:
OK or ERROR
Tcreceive
Sets the player into timecode receive mode.
The Player will respond with:
OK or ERROR
Tcreceiveloop
Sets the player into timecode receive mode and loop the input timecode to the output.